HP StorageWorks XP External Storage user guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (T1706-96017, June 2010)

Figure 41 Overview of configuring external LUs
.
The following is the general procedure for configuring external LUs.
1. Configure the port and system parameters for the external array. For instructions, see the external
LU's documentation, Setting an external array's port, and Notes on connecting external arrays.
2. Start XP External Storage operations. For instructions, see the HP StorageWorks XP Command
View Advanced Edition Software user guide for XP Disk Arrays or the HP StorageWorks XP
Remote Web Console user guide for XP12000/XP10000 Disk Arrays and SVS 200.
3. Change to Modify mode.
For instructions, see the HP StorageWorks XP Remote Web Console user guide for
XP12000/XP10000 Disk Arrays and SVS 200.
4. Set the external array port attribute to External. For instructions, see Setting a local array's port
attributes.
5. Perform the Discovery operation.
In the Device tree on the LU Operation pane, select an external array, and select Discovery (see
Mapping external LUs (Add LU)).
NOTE:
To perform Discovery operations, XP Command View Advanced Edition Software or Remote
Web Console must be in Modify mode.
6. Display the LU Operation pane, right-click the external LU to be mapped as an internal LDEV in
the Device list, and select Add LU or Add LU (Auto). The Add LU or Auto Map Setting pane
appears.
Configuring external LUs84