HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

Change iSCSI Target operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[Install],Change iSCSI Target,,Normal end,
Seq.=xxxxx
+{Port,HostGrpID,Target name,Alias}=[{1E,0x05,iqn.xxxxxxxxxxxxxxxxxxxx,aaaaaaaaaa},
{3E,0x05,iqn.yyyyyyyyyyyyyyyyyyyy,bbbbbbbbbb}],Num. of iSCSI Targets=2
[Install]
Install function
Change iSCSI Target
Change iSCSI Target operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (000000 to 999999)
Detailed Information
Detailed information displays for this operation, as shown in the following table.
Table 50 Detailed information for Change iSCSI Target operation
DescriptionItem
The name of the port where the iSCSI Target has been changed.Port
The host group number where the iSCSI Target has been changed.HostGrpID
The iSCSI Target name changed.Target name
The alias of the iSCSI Target name changed.Alias
The number of iSCSI Name changed.Num. of iSCSI Targets
Change WWN operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[Install],Change WWN,,Normal end,Seq.=xxxxx
+{Port,HostGrpID,WWN,Change WWN,Change NickName}=[{XX,0xXXX,0xXXXXXXXXXXXXXXXX,
0xXXXXXXXXXXXXXXXX,XXXXXXXXXXXXXXXX}],Num. of WWNs=1
[Install]
Install function
Change WWN
Change World Wide Name (WWN) operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (000000 to 999999)
Install function92