HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

DescriptionItem
Indicates whether DFW use to the remote volume is set or not. This value is output
when the synchronous pair is created only. When the asynchronous pair is created,
a hyphen (-) is output.
Not required: DFW not required, Required: DFW required
DFW
Indicates whether to transfer timestamp of the host to the remote volume when the pair
is created. This value is output when the asynchronous pair is created only. When the
asynchronous pair is created, a hyphen (-) is output.
Enable: Transfer, Disable: Do not transfer.
TS
The consistency group number of the consistency group (CT group) that the created
pair belongs to. This value is output when the asynchronous pair is created only.
CTG
The error level set (handling in case of trouble). This value is output when the
asynchronous pair is created only.
Volume: Volume (suspended by appropriate pair); Group: Group (suspended by
consistency group)
Error Level
The result of operation.
Normal end: Normal end, Error(xxxx-yyyyy): Abnormal end
xxxx: Part code, yyyyy: Error code
Result
The number of created pairs.Num. of Pairs
Change Async Option operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx,00:00,[TC z/OS(R)],Change Async Option,,Normal end,
Seq.=xxxxxx
+{CLPR,Rate(%),PPRC Command}={00,050,16CT Compatible}
[TC z/OS]
TrueCopy z/OS function (for IBM z/OS)
Change Async Option
Change Async Option operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of the log entry (000000 to 999999)
Detailed Information
Detailed information for this operation is shown in the following table.
Table 220 Detailed information for Change Async Option operation
DescriptionItem
The CLPR number.CLPR
The specified pending update data rate.Rate(%)
XP Audit Log reference guide 239