HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

DescriptionItem
The number of restored pairs.Num. of Pairs
Pairsplit-r operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[CAXP],Pairsplit-r,,Normal end,Seq.=xxxxxx
+{P-VOL(Port-G-ID-LUN), S-VOL(Port-G-ID-LUN),Type, S-VOL Write,Kind,Range,Mode, Result}=
-{1A-0x00-0x000, 1B-0x00-0x000,P-VOL,Disable,S-VOL,Group,Drain,Normal End},
{1A-0x00-0x001,Disable,S-VOL,Group,Drain,Normal End},(snip)
-(snip), Num.of Pairs=xx
[CAXP]
Continuous Access XP function
Pairsplit-r
Pairsplit-r operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of the log entry (000000 to 999999)
Detailed Information
Detailed information for this operation is shown in the following table.
Table 216 Detailed information for Pairsplit-r operation
DescriptionItem
The port number, host group number and LUN of the primary volume in the restored
pair sequentially.
P-VOL(Port-G-ID-LUN)
The port number, host group number and LUN of the primary volume in the restored
pair sequentially.
S-VOL(Port-G-ID-LUN)
The volume type of the volume on the primary site.
P-VOL: Primary volume, S-VOL: primary volume
Type
Indicates whether writing to the primary volume is enabled.
Enable: Write enable, Disable: Write disable
S-VOL Write
The suspend type set.
P-VOL Failure: P-VOL write disable, S-VOL: P-VOL write enable
Kind
The suspend rage set. This value is output when the asynchronous pair is split only.
Group: Group (all asynchronous pairs in the consistency group),
LU: LU (specified asynchronous pair only)
Range
The setting of unreflected data handling. This value is output when the asynchronous
pair is split only.
Drain, Purge
Mode
Continuous Access XP function234