HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

WWN is selected as the parameter. The operation uses the following parameters, as shown in the
following table.
Table 202 Parameters for Set Ctrl Kind operation
DescriptionParameter
Port Control is applied without the All Thresholds value being set.Port
Port Control is applied with the All Thresholds value being set.All Port
WWN Control is applied. This value is output whether the All Thresholds value
is set or not.
WWN
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of the log entry (000000 to 999999)
Set Prio Port operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[PFC],Set Prio Port,,Normal end,Seq.=xxxxx
+{Port,Priority,Use,Threshold/Upper Limit,Mode}=[{1A,Non-Prio,Enable,XXXXXXXX,IOPS},
{3A,Prio,Disable,,}],Num. of Ports=2
[PFC]
Performance Control function
Set Prio Port
Set Priority (Prio) Port operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of the log entry (000000 to 999999)
Detailed Information
Detailed information for this operation is shown in the following table.
Table 203 Detailed information for Set Prio Port operation
DescriptionItem
The port name.Port
The attribute set to the port.
Prio: Prioritized port, Non-Prio: Non-prioritized port
Priority
Indicates whether the threshold is set or not in case of the prioritized port and whether
the upper limit value is set or not in case of non-prioritized port.
Enable: Value is set, Disable: Value is not set.
Use
XP Audit Log reference guide 221