HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

DescriptionItem
The number of set minimum paths.Min. Path
The value of set RIO MIH (Remote I/O Missing Interrupt Handler) timer (wait
time until data copy from MCU to RCU is completed). The unit is second.
MIH Time(s)
The round-trip response time set (delay time for round-trip remote I/O). The unit
is millisecond. This value is output when Continuous Access XP or TrueCopy for
z/OS is used.
Round Trip Time(ms)
The set incident of the RCU. This value is output only when TrueCopy for z/OS
is used.
“only to RCU host” or “to any host” is output.
Incident
Indicates whether CGROUP (FREEZE/RUN) PPRC TSO command support is
enabled or disabled. This value is output only when TrueCopy for z/OS is used.
Enable or Disable is output.
FREEZE
The number of port pairs set.Num. of Port Pairs
Change RCU Option operation
Example 1 (CU Free is used)
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[RCU],Change RCU Option,,Normal end,Seq.=xxxxx
+{S/N,Path Gr. ID,Controller ID,Min. Path,MIH Time(s), Round Trip Time(ms),Incident,
FREEZE}={99999,Default,4,08,015,001,only to RCU host,Disable}
Example 2 (CU Free is not used)
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[RCU],Change RCU Option,,Normal end,Seq.=xxxxx
+{S/N,SSID,Controller ID,Min. Path,MIH Time(s), Round Trip Time(ms),Incident,
FREEZE}={99999,0x0004,4,08,015,001,only to RCU host,Disable}
[RCU]
Remote Control Unit function
Change RCU Option
Change Remote Control Unit (RCU) Option operation
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of the log entry (000000 to 999999)
Detailed Information
XP Audit Log reference guide 189