HP StorageWorks XP Audit Log reference guide: HP XP12000 Disk Array, HP XP10000 Disk Array, HP 200 Storage Virtualization System (5697-8004, March 2009)

TOD Change is the selected parameter for example 1, Synchro. Infor is the selected parameter for
example 2, and NAS Time Zone is selected for example 3. This operation uses the following
parameters, as shown in the following table.
Table 93 Parameters for Set Subsystem Time operation
DescriptionParameter
The date and the time.TOD Change
The setting of time correction function.Synchro. Infor.
The time zone of NAS PCB.NAS Time Zone
Normal end
The operation has ended normally.
Seq.=xxxxxx
Sequence number of log information (000000 to 999999)
Detailed Information
Detailed information displays for this operation, as shown in the following table.
Table 94 Detailed information for Set Subsystem Time operation
DescriptionItem
Indicates the date and the time in the format of YYYY/MM/DD HH:mm:SS
.(YYYY: year, MM: month, DD: date, HH: hour, mm: minute, SS: second).
Time
Indicates whether the time correction function is valid or invalid.
Valid: Enable, Invalid: Disable
Use Synchro.
The IP address of SNTP server.SNTP IP
The port used by SNTP server.SNTP Port
The time zone.Time Zone
The time when the time correction function is executed. Only HH (Hour: 00 to
23) is indicated for the execution time.
Check Time
System Option operation
user-name,xx,YYYY/MM/DD,HH:MM:SS:xxx, 00:00,[Install],System Option,,Normal end,Seq.=xxxxx
+Spare Disk Recover=Interleave
+Disk Copy Pace=Medium
+Copy Operation(Correction Copy)=ON
+Copy Operation(Dynamic Sparing)=OFF
+Read Configuration Data Mode=ON
+PowerLost Mode=MemoryBackupMode
+{External USP,min}={ON,8}
+{Cache Segment Size(SideA,SideB)}={64(64,64)}
+Link Failure Threshold=0
+Power Supply Type=3-phase
+{DKU,AC-BOX}=[{DKU-R1,3-Phase},{DKU-R2,3-Phase}],Num. of AC-BOXs = 2
+{DKU,PDU}=[{DKU-R1,HITACHI Original},{DKU-R2,HITACHI Original}],Num of PDUs = 2
+{CU:LDEV,Destage}=[{0x00:0x00,ON},{0x00:0x01,OFF}],Num of LDEVs=2
+{LPR,Cache Tuning}=[{System,Level3}],Num. of LPRs=1
+{LPR,Command Control}=[{System,0x0010}],Num. of LPRs=1
XP Audit Log reference guide 125