HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
0605 8500
The program product is not
installed.
Install the program product.
W
5
0605 8501
The command was rejected,
because a status transition
was in progress.
Wait for a while, and retry
the operation.
W
5
0605 8502
You cannot re
serve the
volume, beca
use a
Continuous
Access pair
exists in th
esamesubsystem
frame.
Delete the Continuous
Access pair.
W
5
0605 8503
You cannot create the new
pair, because a Continuous
Access pair exists in the
same subsystem frame.
Delete the Continuous
Access pair.
W
5
0605
8504
The command was rejected.
The operation failed,
because of one of the
following reasons:
1. You cannot execute
the operation on the
specified pair/volume.
2. ThepairsoftheNormal
volume and CV c annot
execute QuickRestore.
Check the pair or volume
status.
W
5
0605 8505
The requested command is
invalid.
If the problem persists, call
technical suppor t.
W
5
0605 8506
The command was rejected.
The specified S-VOL is being
used from the host or by a
Continuous Access volume.
Change the spec ified S-VOL
to other volume, or stop
using the S-VOL in the host
or Continuous Access, and
then retry the operation.
W
5
0605 8507
The Pairsplit command was
issued to the pairs in a PSUS
status.
The Pairsplit command was
issued to the pairs in a PSUS
status.
You cannot execute the
Pairsplit command because
the pair is already in the
PSUS status.
W
5
0605 8508
Th
e Paircreate command
w
as issued to the pairs in a
P
SUS status.
You cannot execute the
Pairsplit command because
the pair is already in the
PSUS status.
W
5
0605 8509
The Split command with the
QUIESCE specification was
issued to a secondary boot
device.
Check the contents, and
retry .
W
5
0605 8510
The M-VOL Suspend
command was issued to
a secondary boot device.
Check the contents, and
retry .
W
5
0605 8511
You cannot reserve the
volume, because a path
group is set.
Disconnect the R-VOL from
the host, or delete the
Continuous Access path.
W
5
90
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes