HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
8505 5 50 27
The cache size is incorrect.
CLPR No:%s(SLPR No:%s)
Correct the settings of
the cache size, and then
retry the operation. If
this problem persists, call
technical support.
E5
8505 5 50 2 8
The specified cache size
is less than the minimum
required.
CLPR No:%s(SLPR No:%s)
Set the cache size to be
equal to or greater than the
required minimum value,
and then retry the operation.
If this problem persists, call
technical support.
E5
8505 5 50 2 9
Thetotalcachesizeis
incorrect.
Set the cache si ze correctly,
and then retry the operation.
If this problem persists, call
technical support.
E5
8505 5 5030
The SLPR that CU belongs
to does not match the SLPR
that LDEV belongs to.
Change the settings so that
the CU list and the Parity
Group list are matched,
and retry the operation.
Ifthesameproblem
persists despite retrying,
call technical support.
E5
8505 5 5031
LUN cannot be set across
plural SLPRs.
Change the settings so
that the port list and the
LU in the parity group are
matched, and retry the
operation. If the same
problem persists despite
retrying, call technical
support.
E5
8505 5 5032
TheLUSEvolumecannotbe
set across plural SLPRs.
Verify that the list of parity
groups including LDEVs that
con
figure the LUSE volume
do
es not contain incorrect
in
formation. If the same
pr
oblem persists despite
r
etrying, call technical
s
upport.
E5
8505 5 503 3
Thesameportisalready
registered in a different
SLPR.
Assign a different port
name (port number), and
then retry the operation. If
this problem persists, call
technical support.
E5
8505 55228
This function is not available.
Disk/Cache Partition is
required to cr eate SLPR or
CLPR.
Install the program product.
E5
8505
55577
You cannot assign the CU
number to the SLPR across
multiple CU groups.
SLPR No:%s
Check the selection of the
CU number and change the
settings.
E
6
8505 5 5 578
You cannot assign the port
to the SLPR across multiple
CU groups.
SLPR No:%s
Check the selection of
the port and change the
settings.
E
6
Remote Web Console error codes
349