HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
8105 1351
The high-speed or
initiator/external mix
mode can not be set to the
specified port because of
the attribute of the p ort.
Cannot set to high-speed
mode because the
port attributes are
mixed, or cannot set to
internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes,
and then retry the operation.
E
6
8105 1352
Logical paths remain on
the Fibre-MCU port. This
operation may cause a fatal
damage to the logical paths.
Please stop this operation.
If you want to continue this
operation, please remove
the logical paths from the
MCU port first .
Since the port you are trying
to set is for Fibre Continuous
Access, you need to delete
the logical path, and then
set.
E
2
8105 1353
S-VOLs remain on the
Fibre-RCU port. This
operation may cause a
fatal damage to S-VOLs.
Please stop this operation.
If you want to continue this
operation, please remove
theS-VOLsfromtheRCU
port first.
Since the port you are trying
to set is for Fibre Continuous
Access, you need to delete
the S-VOL logical path
which is set to RCU Target ,
and then set.
E
2
8105
135 4
Failed to add the WWN to
the initiator port.
Theportyouaretryingto
set is for Fibre Continuous
Access. You need to change
the attribute when adding a
WWN. Attribute (TarGet or
RCU TarGet)
E
2
8105 1355
Thehostmodeofthehost
group connected to the
Initiatorportcannotbe
changed.
Theportyouaretryingto
set is for Fibre Continuous
Access. You need to change
the attribute when adding a
WWN. Attribute (Target or
RCU Target)
E
2
8105 1356
The host group cannot be
added to the Initiator port.
Theportyouaretryingto
set is for Fibre Continuous
Access. You need to change
the attribute when adding a
host group. At tribute (Target
or RCU Target)
E
2
8105 1357
S-VOLs remain on the
Fibre-RCU port. This
operation may cause a
fatal damage to the S-VOLs.
Please stop this operation.
If you want to continue this
operation, please remove
theS-VOLsfromtheRCU
port first.
The specified Port is for Fibre
Continuous Access. P lease
delete a logical path, and
then retry the operation.
E
6
334
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes