HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
8105 1124
An error occurred. If this
problem persists, please call
technical suppor t.
The command device setting
and the command device
security setting a re incorrect.
You cannot do any of
the following to the same
volume:
• Specify the volume as
a command device and
disable command device
security on the volume.
• Specify the volume as
a non-comm and device
and enable command
device security on the
volume.
The setting method of
command device/command
device security is incorrect.
The following sett ings are
invalid. *Set command
device + Release command
device security
*Release command device
+ Set command device
security
It does not occur normally
because it is guarded in
the screen. Contact the
program m aker.
E
2
8105 1125
There are no host groups
wher e the WWN will be
registered.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
8105 1126
Avolu
me set as a command
devic
ecannotbeusedas
acomp
onent of a LUSE
volu
me. Select another
volu
me.
Correct the specified
contents, and request again.
E5
8105 1127
An error occurred. If this
problem persists, please call
technical suppor t.
CHA high-speed mode is
specified to unmounted
CHA. The error does not
occur normally because it
is guarded in the screen.
Contact the program maker.
E
2
8105 1128
An error occurred. If this
problem persists, please call
technical suppor t.
Channel speed change
is requested, but Fibre
PCB does not support it.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
E
2
8105 1130
The specified name is the
same as the system default
name. Please change the
name.
Correct the specified
contents, and request again.
E
6
8105 1131
Failed to set the host group
because the number of
host groups exceeds the
maximum that can be set in
aport.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
Remote Web Console error codes
331