HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
0003
112 4
The command device setting
and the command device
security setting a re incorrect.
You cannot do any of
the following to the same
volume:
• Specify the volume as
a command device and
disable command device
security on the volume.
• Specify the volume as
a non-comm and device
and enable command
device security on the
volume.
The setting method of
command device/command
device security is incorrect.
The following sett ings are
invalid.
1. Set command device
+ Release command
device security
2. Release command
device + Set command
device security
It does not occur normally
because it is guarded in
the screen. Contact the
program m aker.
E
2
0003 1125
There are no host groups
wher e the WWN will be
registered.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
0003 1126
Avolum
e set as a command
device
cannot be used as
acomp
onent of a LUSE
volum
e. Select another
volum
e.
Correct the specified
contents, and request again.
E
6
0003 1127
An error occurred. If this
problem persists, please call
technical suppor t.
CHA high-speed mode is
specified to unmounted
CHA. The error does not
occur normally because it
is guarded in the screen.
Contact the program maker.
E
2
0003 1128
An error occurred. If this
problem persists, please call
technical suppor t.
Channel speed change
is requested, but Fibre
PCB does not support it.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
E
2
0003 1129
An error occurred. If this
problem persists, please call
technical suppor t.
W
hen WWN is registered
in LUN Manager operation,
the number of WWNs you
can register is exceeded.
The error does not occur
normally because it is
guarded in the screen.
Contact the program maker.
E
2
0003 1130
You cannot specify the
default nickname when
setting the nickname of a
host group or a host.
Correct the specified
contents, and request again.
E
6
Remote Web Console error codes
33