HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
0003
11 0 4
An error occurred during
SVP processing. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical suppor t.
E
2
0003 1105
An error occurred during
SVP processing. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical suppor t.
E
2
0003 1108
When changi
ng the
configuration of the
command device, you
cannot set the command
device to the following
volumes:
• Reserved volumes for
Auto LUN
• Just-in-Time volumes
• Volumes other than the
open-system volumes
(including unmounted
volumes).
Command dev
ice setting
is requested for Reserve
volume of Auto LUN/Just
in Time volume. Or it
is requested for volumes
other than open volumes
(including un-installed
volumes). The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
0 0 0 3 111 0
An error occurred. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical suppor t.
E
2
0003
1111
An error occurred. If this
problem persists, please call
technical suppor t.
A nickname is not specified
when the configuration
change of LUN Manager is
requested. The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
0 0 0 3 1113
The
specified volume is
cur
rently used by Parallel
Ac
cess Volume and is not
av
ailable for VLL operation.
Aft
er changing the volume
whi
ch creates CV in VLL
op
eration, retry the VLL
op
eration.
E
6
0 0 0 3 1116
An error occurred. If this
problem persists, please call
technical suppor t.
You have not specified
the value when registering
WWN. Or zero is set as
the WWN value. The error
does not occur normally
because it is guarded in
the screen. Contact the
program maker.
E
2
0003 1123
Command device security
cannot be set to the specified
volume because the volume
is not a command device.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
32
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes