HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
6805 55217
The maximum number of
SLPRsthatcanbesetwas
exceeded.
Please specify the number of
SLPRs within the valid range.
W
5
6805 55218
The Level 1 Sleep setting is
incorrect.
Please correct the setting,
and then retry. If the same
problem persists despite
retrying, call technical
support.
W
5
6805 55219
The Sleep Time setting is
incorrect.
Please corr
ect the setting,
and then retry. If the same
problem persists despite
retrying, call technical
support.
W
5
6805 55220
The SLPR number is
duplicated.
Please correct the setting,
and then retry. If the same
problem persists despite
retrying, call technical
support.
W
5
6805 55221
The CLPR number is
duplicated.
Please correct the setting,
and then retry. If the same
problem persists despite
retrying, call technical
support.
W
5
6805
565 2 4
This function cannot be used
by the storage partition
administrator.
Select another window. To
setthisfunction,contactthe
storage a dministrator.
E
3
Tabl e 59 E rror C odes — Part Code 6810
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
6810 5122
No data has been changed.
The operation has been
rejected because there is no
data to set. Please select
[OK], a nd then go on to the
next operation.
W0
6810
7440
An error occurred during
processing. If this problem
persists, please call
technical suppor t.
If this problem persists, call
technical support.
E
2
6810 9101
D
oyouwanttocancel?
To ca ncel the operation,
select [OK].
i
0
6810 9102
Do you want to apply?
To execute the operation in
Preset, select [OK].
i
0
6810 9106
The value that is under setup
is not reflected yet. Do you
want to change the mode?
To change the mode, select
[OK]. To not change the
mode, select [Cancel].
i
0
6810 9107
The value that is under setup
is not reflected yet. Do
you want to continue the
operation?
To continue processing,
select [OK]. To stop
processing, select [Cancel].
i
0
Remote Web Console error codes
287