HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
6610 9306
The Universal Replicator for
Mainframe function is not
installed in this controller.
You cannot create pairs.
Obtain a license for
Universal Replicator for
Mainframe, and then install
it.
W
5
6610 9308
Yousetthesamepathmore
than once. The duplicate
paths are excluded.
Since there are duplicated
paths in the added paths,
the duplicated paths will be
eliminated. Select [OK] to
continue.
W
0
6610 9 309
All paths which you set have
already been registered.
This operation will terminate
because there is no path
which can be added.
Since all th
e added paths
are redunda
nt, the paths
cannot be a
dded. Select
[OK] an d co
ntinue.
W0
661 0 9327
The monitoring time is over,
but the history file is not fully
updated yet.
Select [Refresh] to update
the history file. If this
problem persists, call
technical support.
i
0
661 0 9332
This operation is not applied
yet.
Select [OK], and then
continue the operation.
i
0
6610 55036
Too many data volumes in
the journal group.
Check th
e number of data
volumes
in the journal
group.
After that, delete
unused
data volume pairs,
or regi
ster them in another
journ
al group.
i
0
6610 55037
Too many mirrors in the
journal group.
Check the number of mirrors
in the journal group. After
that, delete unused mirrors,
or register them in another
journal group.
i
0
6610 55038
Too many mirrors in the
subsystem.
Check the number of mirrors
in the journal group, and
then delete unused mirrors.
i
0
661
0
550
39
You a
re specifying Group
for the range and trying to
manipulatethesamemirror.
Select only one data volume
pair in the mirror when you
specify Group for the range.
Che
ck the range setting. If
you specify Group, select
only one data volume p air
in the mirror.
i
0
6610 55202
The specified controller ID
cannot be used.
Please check the specified
controller ID.
W
0
6610 5520 7
Some of the specified values
are incorrect. Two times the
valueofM-JNLCacheplus
the value of R-JNL Cache
must be equal to or less
than 100. Or, the value
of Threshold of start As ync
JNL must be equal to or less
than the value of Threshold
of start Sync JNL.
Valueof“Thresholdofstart
Async JNL” must be equal
to or less than the value
of “Threshold of start Sync
JNL.”
W0
Remote Web Console error codes
279