HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
6005 8931
Logical paths exist on the
RCU port .
Please delete the logical
paths on the specified port
and retry the operation.
E
4
6005 893 2
Since the configuration
definition of the specified
CU number does not exist,
the logical paths between
MCUandRCUcannotbe
established.
Please check whether
specified CU number is
defined as configuration
information.
W4
6005 8933
The Paircreate operation
failed because specified
M-VOL is the NAS system
volume.
Check the configuration of
the specifi
ed M-VOL.
W4
6005
8934
The Paircreate operation
failed because specified
R-VOL is the NAS system
volume.
Check the configuration of
the specified R-VOL.
W4
6005 8935
A pair cannot be created
because the specified
M-VOL is a NAS user
volume and it is being used
as a primary data volume
for Continuous Access
Journal.
Please specify another
volume.
i
4
6005 8936
The Pa
ircreate operation
faile
d. The version of the
spec
ified RCU does not
supp
ort Continuous Access
with
the NAS volume.
Check the microcode version
of the RCU.
W4
6005 8937
The Paircreate operation
with the fib re-channel
remote copy connection
failed because there are
pairs with the serial remote
copy connection in the
specified MCU.
Please delete a ll the pairs
with the serial remote copy
connection in the specified
MCU, and then retry the
operation.
W4
6005 8938
The Paircreate operation
with the serial remote copy
connection failed because
there are pairs with the
fibre-channel remote copy
connection in the specified
MCU.
Please delete a ll the pairs
with the Fibre Channel
remote copy connection in
the specified MCU, and
then retry the operation.
W4
6005 8939
The specified M-VOL cannot
be used.
Check the LUN of the
specified M-VOL by using
RAID Manager, and specify
the LUN with the value less
than 1,024 for the M-VOL.
W4
6005
89 40
The operation failed
because the specified
R-VOL is in a Read Only
status by Volume Retention
Manager.
Confirm the status of the
specified R-VOL.
i
4
Remote Web Console error codes
21 1