HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
6005 8803
ToomanyRCUsinthisCT
Group.
The add pair operation
failed because there are
toomanyRCUsinthisCT
group. If the timer type
is None, and then 4 RCU
have already been added.
If the timer type is Local or
System, and then 1 RCU
has already been added.
Check configuration of CT
group numbers already used
on both MCU and RCU.
Register a new CT group.
i
4
6005
8804
Copy mode cannot be
changed.
Theresumepairoperation
failed. The volume and the
copy mode must be either
both asynchronous or both
synchronous. Verify that the
status of the volume and the
copy mode match, and then
retry the operation.
i
4
6005 8805
CT Group is not active in
the RCU.
The res
ume pair operation
faile
d, because there is no
R-VOL
in the CT Group.
Verif
y the status of the CT
grou
pintheMCU/RCU.
If an M-VOL exists, delete
it and retry the add pair
operation.
i
4
6005 8806
CT Group Option cannot be
changed unless deleting or
suspending all asynchronous
pairs in the group.
To change the CT group
option (timer type or time
out), either delete all
asynchronous pairs in the
group, or verify the status of
the RCU CT Group option
and set the same option as
the MCU.
i
4
6005 8807
ToomanyMCUsinthisCT
Group.
The add pair operation
failed because there are
too many MCUs in this CT
group. If the timer type is
System, and then 4 MCUs
have already been added.
If the timer type is local
or none, and then 1 MCU
has already been added.
Register a new CT group.
i
4
6005 8808
Please retry Add Pair
(Paircreate)/Resume Pair
(Pairresync) operation in a
few minutes.
The add/resume pair
operation failed, because
the either the specified
volume or another volume
in the same group is being
changed to simplex or
suspend status. Retry the
operation after the status
change is completed.
i
4
Remote Web Console error codes
199