HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
6005 8734
The Fibre-Continuous Access
function is not installed in
the specified RCU.
Please install the program
product key in the RCU.
i
4
6005 8735
Invalid RCU serial number,
SSID, Link Address or
Controller ID.
Check the serial number,
SSID and link address
of the RCU, and set the
correct value. Then retry
the operation. If the same
error occurs, call technical
support.
E
4
6005 8736
The specified RCU or SSID
contains some Continuous
Access volume pairs.
Delete all
Continuous Access
volume pai
rs of the specified
RCU or SSID
, and retry the
operatio
n.
i
4
6005 8737
An internal error occurred. Please call technical support.
E
4
6005 8738
Continuous Access is not
supported under the MCU
Controller emulation type.
The emulation type of the
MCU d oes not support
Continuous Access. To use
Continuous Access, Please
call technical support.
i
4
6005 8739
NVS status of MCU is not
active.
The MCU
NVS status
specifi
ed by the host is not
active
.SettheNVStoon
for th
eMCU,usingany
attac
hedhost,andthen
retry
the operation.
i
4
6005 8740
NVS status of RCU is not
active.
The RCU NVS status
specified by the host is not
active. Use any attached
host to set the NVS to on for
the MCU, and then retry the
operation.
i
4
6005
87 41
The logical paths between
the MCU and RCU are not
established.
Check the path status
between the MCU and the
RCU.
i
4
6005
87 42
Pinned track(s) exists on the
M-VOL.
Ch
eck the status of the
M-
VOL tracks, an d clear the
p
inned tracks.
W4
6005
87 43
Pinned track(s) exists on the
R-VOL.
Check the status of the
R-VOL tracks, and clear the
pinned tracks.
W4
6005
87 44
The specified M-VOL
condition is not valid for
Continuous Access.
The M-VOL is not available
for the requested operation,
because of one or more of
the following reasons:
1. The volume is blocked.
2. Thevolumeisunder
maintenance.
3. The volume is copying
data (correction copy
or drive copy) .
4. Thevolumeiscorrection
access condition.
Check the logical
device status of the
W4
192
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes