HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Tabl e 39 Error Cod es — Part Code 4010
Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
4010
1030
Part of the range is already
in use.
Correct the specified
content, and issue the
request again.
i
0
4010
1032
The specified v
alue is
outside the va
lid range.
Correct the specified
content, and issue the
request again.
i
0
4010
2080
Prestaging not completed.
Wait for a while, and
press the Refresh button,
and then change the same
configuration again. Or
check the DKC status (if it
is not blocked). If the same
error occurs, please call
technical suppor t.
E
6
4010 5010
The value specified as the
ending address for the
data to be pla ced in cache
is smaller than the value
specified as the starting
address.
Correct the values specified
as the starting and ending
addresses, and then retry
the operation.
W
5
4010
5011
The value specified as the
Number of Cache Residency
Manager areas is equal to
or less than one cylinder.
Correct the specified
content, and retry.
W
5
4010
5030
No deletion area is
specified. Retry the
operation to specify the
deletion area.
Correct the specified
content, and retry.
W
5
4010
5058
The Cache Residency
Manager settings that
exceed the maximum size
or maximum available area
are invalid.
Correct the Cache Residency
Manager settings, and then
retry the operation.
W
5
4010 706
0
An e
rror occurred in the
cli
ent logic.
Please call technical support.
E
2
4010 7440
An error occurred during
processing. If this problem
persists please call technical
support.
An error occurred. If
this problem persists, call
technical suppor t.
E
2
4010
9000
Prestaging has completed.
The normal end was carried
out. Please select the OK
button and close the dialog.
i
0
4010
9010
T
he system will set the
contents.
i
0
4010
9060
Do you want to delete?
i
0
160
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes