HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

• The word M-VOL in TrueCopy for Mainframe messages is equivalent to P-VOL in Continuous
Access messages.
• The word R-VOL in TrueCopy for Mainframe messages is equivalent to S -VOL in Continuous
Access messages.
• Part code: The I D of the application that issued the message. In
“Sample Message Window (Information Level Message)” on page 13 the part code is 11 0 .
• M essage number: Decimal number within the range of 0000 to 99999. In
“Sample Message Window (Information Level Message)” on page 13 the message number is
9102.
Note: If Remote Web Console starts and displays the following message, see the code and number the
(YYYY ZZZZZ) represents. A check box may be indicated in the message window. If you check the check
box, note that the message will not be displayed until you lo gin again.
A network error occurred, the server is not ready, or an error occurred
in the serve
r. (YYYY ZZZZZ)
Remote Console-Remote W eb Console Err or Codes
Note: To find solutions to the HP Remote Web Console for storage system errors, see the tables of this
manual, or the Troubleshooting chapter in the user guides for the program products causing the errors.
The tables list the error cod es and error messages for Remote Web Console and provides recommended
action for the error conditions.
Note: In some cases, the Recomm en ded Action column may be blank. In these circumstances, the user
should take actions based on instructions provided in the error message and based on what the user is
trying to accomplish. The tables also provide the severity level and failure level of the error conditions.
Severity Levels. The severity levels for the error codes are:
• i: Information
• E:Error
• W: Warning
• N: The server is unable to accept the request from Remote Web Console. One possible cause is
that some process is in progress at the server. This message does not indicate an error.
Failure Levels. The failure levels for the error codes are:
• 0:NoError
• 1: Select MSG OK to end forcibly
• 2:AllRefreshorExitisvalidonly
• 3: All Refresh, Refresh, or Exit is valid and the buttons, other than the buttons of the functions in
which the error occurred, are valid.
• 4: To make refresh possible
• 5: No status change
• 6: No change with refreshing automatically
• 7: Remote Web Console is automatically switched to view mode. If necessary, change the
mode to Modify.
Note: The iSCSI function is planned for future support.
14
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes