HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
1005 1920
The path definition between
NAS cluster and LDEV is
incorrect
• ThesameLDEVis
specified in different
NAS clusters.
• ThesameLDEVis
specified for different
LUNs, in the CHN pair
of the same NAS cluster.
Check the setting, and then
retry the operation.
E
6
1005 1921
The specified volume is not
aLUSEvolume.
Check the volume, and then
retry the operation.
E
6
1005 1 922
LDEVs that
are not normal
are includ
ed in the
componen
tofaLUSE
volume.
Restore th
eLDEVs,thenretry
the opera
tion.
E
6
1005 2005
An error occurred during
SVP processing. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical support.
E
2
1005 2009
An error occurred during
SVP processing. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical support.
E
2
1005 2010
The LDEV is being used by
the host, or an error occurred
during SVP processing.
Recovery processing may
take about 1 minute. Please
wait for a while.
Check if the host is
performing I/O operations
on the target path or volume.
E
6
1005 2013
An error occurred during
SVP processing. If this
problem persists, please call
technical suppor t.
If this problem persists, call
technical support.
E
2
1005 2015
An error occurred while
connecting to the subsystem.
Please wait for a while, and
then retry the operation.
A communication error
occurs. If the same error
occurs despite retrying, call
technical support.
E
6
1
005
2
03 2
C
ommunication busy.
P
lease retry later.
Please retry later .
E
3
1005 2082
Processing is disabled
because the host is mounted
or the device is reserved.
The host is mounted or
thedeviceisreserved.
Please unmount the host
and cancel reservation of
the device. If the host is an
AIX host, unmount the host,
and execute the varyoffvg
command.
E
6
1005 2083
The subsy stem status is
invalid. Please call technical
support.
Check the DKC status and
the current status of the
configuration setting. If
necessary, re-execute the
setting operation.
E
2
Remote Web Console error codes
119