HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recomme n ded Ac tio n
Severity
Level
Failure
Level
1005 1195
The specified volume(s) are
used as a command device.
Please correct the settings,
and then retry.
E
6
1005 1196
You cannot create a LUSE
volume by concatenating
LUs and Cross-system Copy
LUs.
Please correct the settings,
and then retry.
E
6
1005 1197
You cannot set high-speed
mode to a package
including an external
port.
Please correct the settings,
and then retry.
E
6
1005 1198
Since a path is defined to
aCross-systemCopyLU,
you cannot set high-speed
mode.
Please correct the settings,
and then retry.
E
6
1005 1199
The path cannot be set
to the specified volume
because the volume is not
an open-systems volume.
Check the setting.
E
6
1005 1201
The selec
tion of High Speed
mode/MIX mode is invalid.
The specified port cannot
be changed to High Speed
mode/M
IX mode.
Change th
e parameter to
a path wh
ere the High
Speed mode/MIX mode
can be set, and then retry
the operation.
E
6
1005 1203
High Speed mode/MIX
mode was specified.
However, there are
addresses to which High
Speed mode/MIX mode
cannot be set in the Fibre
Addresses of the specified
ports.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1204
High Speed mode/MIX
mode was specified.
However, there are
topologies to which
High Speed mode/MIX
mode cannot be set in the
topologies of the specified
ports.
The Configuration
information has been
already changed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1350
You could not add the path
to the initiator or external
port.
To add a path, change the
a
ttribute of the specified port
t
o Target or RCU Targ et.
E
6
1005 1351
The high-speed or
initiator/external mix
mode can not be set to the
specified port because of
the attribute of the p ort.
Cannot set to high-speed
mode because the
port attributes are
mixed, or cannot set to
internal/external mix mode
because the combination of
port attributes is different.
Check the port attributes,
and then retry the operation.
E
6
116
HP StorageWorks XP Remote Web Console for Storage System M essages and Error Codes