HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
1005 1181
The specified path cannot be
added, because the volume
is used by a Continuous
Access pair.
Correct the specification,
and then retry the operation.
W
6
1005 1182
An error occurred. If this
problem persists please call
technical suppor t.
If this problem persists call
technical support.
E
2
1005 1183
The port information is
inconsistent with PCB mode
information.
Please correct the por t
information or the PCB
mode information.
W
0
1005
118 4
The port information is
inconsistent with PCB mode
information.
Please correct the por t
information or the PCB
mode information.
W
0
1005 1185
You are trying to inser t
in the linkage operation
including LUSE. (LDEV
number is inserted to the
LDEV numbers created in
LUSE).
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1186
In the linkage operation
including LUSE, the path is
specified to other than the
top.
The Config
uration
information has been
already chang ed.
Please check the settings
and requ
est the setting of the
configuration information
again.
E
6
1005 1187
You cannot expand the LU
because the host mode of
the group with paths which
are defined in the LU is
corresponding to online
LUSE.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1188
An error occurred. If this
problem persists please call
technical suppor t.
If this problem persists call
technical support.
E
2
1005 1189
Fail
ed to delete the specified
use
r LU because it is being
use
dbytheNASpackage.
To delete the specified user
LU, delete the file system
configured on the LU that is
set by this user LU.
Please delete a file system
configured on the user LU,
and then retry.
E
6
1005 1190
To define a path to the
volume from a NAS port or
an iSCSI port, the volume
must be read/write-enabled
and also usable as an S-VOL
(secondary volume).
Please correct settings and
then retry.
E
6
1005 1194
No information can be
changed about this external
port because the port has
an external volume.
Please correct the settings,
and then retry.
E
6
Remote Web Console error codes
115