HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
1005 1132
Failed to set the WWN
because the number of
WWNs exceeds the
maximum that can be set in
aport.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1133
Failed to set the host mode
because the number of
host modes exceeds the
maximum that can be set in
aport.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005
113 4
Failed to set the path
because the number of
pathsexceedsthemaximum
that can be set in a port.
The Configuration
informat
ion has been
already c
hanged.
Please ch
eck the settings
and request the setting of the
configur
ation information
again.
E
6
1005 1135
An error occurred. If this
problem persists, please call
technical suppor t.
When PORT information
(Fibre Address/Fibre
Topology/Channel Speed)
is set, multiple change
instructions are set to the
samePORT.Theerrordoes
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
1005 1136
An error occurred. If this
problem persists, please call
technical suppor t.
When CHA high-speed
mode is set, multiple change
instructions are set to the
samePORT.Theerrordoes
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
1005 1137
Failed to form a LUSE
volume because the number
of LUSE volumes exceeds the
maximum that can be set in
adiskarraysubsystem.
The Configuration
in
formation has been
al
ready changed.
Pl
ease check the settings
and request the setting of the
c
onfiguration information
a
gain.
E
6
1005 1138
An error occurred. If this
problem persists, please call
technical suppor t.
An error occurred. If
this problem persists, call
technical support.
E
2
1005
114 0
Because the Port Group
settingisdone,itis
impossible to change.
Please release the Port
Group setting.
Please release the P ort
Group setting.
E
2
Remote Web Console error codes
113