HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)
Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
1005 1065
The specified host name
or the host group name is
already registered. (The
host name and the host
groupnamecannotbethe
same.)
Correct the specified
contents, and request the
setting of t he configuration
information again.
E
6
1005 1066
WWN number, which
is not registered, is
specified. (When deleting,
or changing)
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1067
You are trying to register the
same host group number as
the already registered one.
The Configu
ration
information has been
already chang ed.
Please check the settings
and reque
st the setting of the
configuration information
again.
E
6
1005 1068
The specified host group has
not been registered.
The Configuration
information has been
already chang ed.
Please check the settings
and request the setting of the
configuration information
again.
E
6
1005 1108
When changing the
configuration of the
command device, you
cannot set the command
device to the following
volumes:
• Reserved volumes for
Auto LUN
• Just-in-Time volumes
• Volumes other than the
open-system volumes
(including unmounted
volumes)
Command device setting
is requested for Reserve
volume of Auto LUN/Just
in Time volume. Or it
is requested for volumes
other than open volumes
(including un-installed
volumes). The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
1 0 0 5 111 0
A
nerroroccurred. Ifthis
p
roblem persists, please call
t
echnical support.
If this problem persists, call
technical support.
E
2
1005
1111
An error occurred. If this
problem persists, please call
technical suppor t.
Anicknameisnotspecified
when the configuration
change of LUN Manager is
requested. The error does
not occur normally because
it is guarded in the screen.
Contact the program maker.
E
2
Remote Web Console error codes
111