HP StorageWorks Remote Web Console error codes for XP12000/XP10000 Disk Arrays and SVS200 (AE002-96034, October 2007)

Part
Code
Error
Number
Error M essage
Recommended Ac tion
Severit y
Level
Failure
Level
0610 59017
No LDEV is selected. Please
select the LDEV.
Select [OK].
i
0
0610 59020
The setting is insufficient for
automatic mapping. Check
the setting, and then retry
the operation.
Select [OK].
i
0
0610 59021
The automatic mapping
processing was interrupted.
Retry the ope
ration.
i
0
0610 59022
There are not enough
logical volumes to perform
the automatic mapping
operation.
Decrease the number of
external volumes to be
mapped, and then retry the
operation.
i
0
0610 59029
The Check Paths pr ocessing
began. After three minutes,
select the [Refresh] button to
check the path status.
Select [OK].
i
0
0610
59034
The proce
ssing of this
command t
akes some
time to co
mplete. Do
you stil
lwanttoexecute
the comm
and? After you
execut
e the command,
select
[Refresh] to check the
progre
ss.
To continue processing,
select [OK]. To stop
processing, select [Cancel].
W
0
0610 59037
The number of paths
registered to a port has
reached the maximum.
Select [OK] to continue
processing, or select
[Cancel] to stop processing.
When you select [OK],
the processing continues
without counting the path
data registered after the
maximum is reached.
The number of paths
registered to a port has
reached the maximum.
Select [OK] to continue
processing, or select
[Cancel] to stop processing.
When you select [OK],
the processing continues
without counting the path
data registered af ter the
maximum is reached.
W0
0610 59038
Do you want to execute the
Delete LU operation without
writing the cached data to
the volume?
If you do not want to write
the cached data to the
volume, select [OK]. If
you want to cancel the
operation, select [Cancel].
W
0
0
610
59044
No
S-VOL can be assigned
t
otheP-VOL.
Please check the volume.
i
0
0610 5 904 8
The P-VOL and the S-VOL
belong to different SLPRs.
Do you want to continue this
operation?
If you want to continue the
operation, select the OK
button.
i
0
Remote Web Console error codes
105