HP StorageWorks Performance Control XP user guide (T1605-96007, October 2007)

Performance Control XP user guide 59
}
Description
The group subcommand specifies the type of monitoring data you want to export. This command uses an
operand (such as PhyPG and PhyLDEV above) to specify the type of monitoring data.
Table 24 shows monitoring data that can be saved into files by each operand, and the saved ZIP files. For
details on the monitoring data saved in these files, see the tables indicated in the See column.
Table 24 Operands of the group subcommand and saved monitoring data
Operand Pane of Auto
LUN XP
Monitoring data saved in
the file
Saved ZIP file See
PhyPG Physical tab in the
Auto LUN XP pane
Usage statistics about parity
groups
PhyPG_dat.ZIP
1
Table 3
PhyLDEV Usage statistics about logical
volumes
PhyLDEV_dat.ZIP
1
PhyExG Usage conditions about
external LU groups
PhyExG_dat.ZIP
PhyExLDEV Usage conditions about
external LUs
PhyExLDEV_dat.ZIP
PhyProc Usage statistics about
channel processors, disk
processors, and data
recovery and reconstruction
processors
PhyProc_dat.ZIP
1
PhyCSW Usage statistics about access
paths and write pending rate
PhyCSW_dat.ZIP
1
PG LDEV tab in the
Auto LUN XP pane
Statistics about parity,
external LU, or V-VOL groups
PG_dat.ZIP Table 4
LDEV Statistics about logical
volumes in parity, external
LU, or V-VOL groups
LDEV_XXXXX.ZIP
2
Table 5
Port Port-LUN tab in the
Auto LUN XP pane
Statistics about ports Port_dat.ZIP Table 6
PortWWN Statistics about host bus
adapters connected to ports
PortWWN_dat.ZIP Table 7
LU Statistics about LU paths LU_dat.ZIP Table 8
PPCG WWN tab in the
Auto LUN XP pane
Statistics about SPM groups PPCG_dat.ZIP Table 9
PPCGWWN Statistics about host bus
adapters belonging to SPM
groups
PPCGWWN_dat.ZIP Table 10