HP StorageWorks LUN Configuration and Security Manager XP User Guide for the XP1024/XP128 (T1614-96005, March 2006)

LUN Configuration and Security Manager XP user guide for the XP1024/XP128 33
NOTE: If two or more host bus adapters are selected, the Add New WWN (or Add New iSCSI)
dialog box displays repeatedly to let you assign a nickname to each selected HBA (see Figure 15
and Figure 16). If you do not need to assign nicknames to HBAs, enable the The remaining WWNs
(iSCSI Names) do not need names check box and click OK. If you select this option, the Add New
WWN (Add New iSCSI Name) dialog box will not prompt you for additional nicknames.
Figure 15 Add New WWN dialog box (when registering a host that has previously been
connected to the disk array)
Figure 16 Add New iSCSI Name dialog box (when registering a host that has previously been
connected to the disk array)
7. Skip to step 11. If the desired host has never been connected via a cable to any port in the array, only
step 8 through step 10 apply.
8. Right-click the host group and select Add New WWN (Fibre Channel) or Add New iSCSI Name (iSCSI
environment). The Add New WWN (or Add New iSCSI Name) dialog box appears (Figure 13 for
Fibre Channel and Figure 14 for iSCSI).
9. Select the desired host bus adapter from the WWN/iSCSI name list. If the host bus adapter is not in
the list, enter the WWN (iSCSI name) in the box.
10.If necessary, enter a nickname for the host bus adapter.
11.Click OK. The new WWN (iSCSI Name) and nickname appear below the selected host group in the
LU Path tree.
12.Click Apply in the LUN Manager main pane. A confirmation message appears.
13.Click OK. The settings are applied to the disk array.
NOTE: For Fibre Channel environments only: If the WWN table (located in the lower-left corner of the
pane) includes a host that you want to register, you can register the host by selecting the host group in the
LU Path tree, selecting the host from the WWN table, and then clicking Add WWN.