HP StorageWorks External Storage XP user guide (December 2005)

External Storage XP user guide 73
As you select an external volume group number in the Device Tree on the LU Operation pane, the
information shown in Table 7 appears.
• If you access a remote command device from an OPEN host, the remote command device reports
device information about the command device, which is mapped as a remote command device of the
external disk array:
Device information about the command device that the remote command device reports to the host
includes:
• Serial number
•Vendor
•Device name
NOTE: The device name reported to the host is the same as the one displayed in the Device
column of the Device List. For the device names reported to the host, see Table 7.
• The following are restrictions for mapping command devices as remote command devices.
Table 7 Information displayed in the Device column for remote command devices
Storage disk array Information displayed in Device column of
Device List
XP12000 disk array
XP10000 disk array
XP1024/XP128 disk array
TagmaStore™ Universal Storage Platform subsystem
TagmaStore™ Network Storage Controller subsystem
Lightning 9900V series subsystem
SANRISE Universal Storage Platform subsystem
SANRISE Network Storage Controller subsystem
SANRISE9900V series subsystem
SANRISE H12000 subsystem
SANRISE H10000 subsystem
SANRISE H1024/H128 subsystem
Format: “Emulation Type” + “-CM”
Example: OPEN-V-CM, OPEN-3-CM
TagmaStore™ Adaptable Modular Storage subsystem
TagmaStore™ Workgroup Modular Storage subsystem
Thunder 9500V series subsystem
SANRISE Adaptable Modular Storage subsystem
SANRISE Workgroup Modular Storage subsystem
SANRISE9500V series subsystem
DF600F-CM
Table 8 Restrictions on remote command devices
Item Restriction
Emulation type OPEN-V
Number of LDEVs in an external volume 1
IO Suppression mode Disable
Cache mode Disable
Minimum capacity 96,000 blocks (about 47 MB)
Maximum capacity 2 TB