HP StorageWorks Continuous Access XP user guide for the XP10000/XP12000 (December 2005)

Continuous Access XP user guide for the XP10000/XP12000 89
Modifying LU parameters
1. Click the LU on the Pair Settings Parameter list.
2. Right-click, and click Modify. A pane appears.
3. Modify parameters, and click Set.
4. Click Apply on the Continuous Access XP main pane to apply modifications.
Deleting LUs
1. Click the LUs on the Pair Settings Parameter list.
2. Right-click, and click Omit. LUs selected in step 1 are deleted from the Pair Settings Parameter list, and
deleted LUs are out of pair settings operations.
3. Click Apply on the Continuous Access XP main pane to apply the deletion.
The Cancel All command deletes all LUs listed on the Pair Settings Parameter list, and all LUs are removed
from pair settings operations. LUs can also be deleted using the Omit command and selecting all LUs on
the Pair Settings Parameter list. When all LUs are deleted (by the Cancel All or Omit command), the list
status becomes the Volume list.
Viewing Continuous Access XP pair status for LUs and LDEVs (Pairdisplay)
The Pairdisplay command displays detailed Continuous Access XP pair status information.
1. From the Volume list, click the LU.
2. Right-click, and click Pairdisplay. The Pairdisplay pane appears. The Pairdisplay command can be
selected if Subsystem, CU number, or Port number is selected in the tree.
Figure 50 Pairdisplay pane
• P-VOL and S-VOL:
• Port - host group ID - LUN (lowest LDEV number for a LUSE pair).
• Device emulation name.
• Capacity in MB (up to two decimal places).
•Number of blocks.