HP StorageWorks Continuous Access XP user guide for the XP10000/XP12000 (December 2005)

Continuous Access XP user guide for the XP10000/XP12000 65
NOTE: If four RCUs (maximum number of RCUs you can register) are already registered, you cannot
select Add RCU.
Figure 33 Add RCU pane
• RCU S/N: Serial number of RCU being registered. S/N is five digits.
• Controller ID: Controller ID of RCU being registered.
• Logical Adr. (RCU CU#): CU number of RCU being registered. CU number is 0-1F.
• Path Gr.ID: Used to enter the path group ID for using CU Free. To enter the path group ID, clear the
Default check box, and input the value in hexadecimal within the range of 1 to FF. To use the default
ID, select the Default check box.
• SSID: SSIDs of RCU being registered. The XP10000/XP12000 uses one SSID for each set of 256
volumes and four SSIDs per CU image. The SSID is 4-FFFE in hexadecimal.
• MCU-RCU Path: Includes:
• MCU Port: MCU port number. Only Initiators are listed in the drop-down list. Select the MCU port
from the list.
• RCU Port: RCU port number. Select the RCU Target port.
• Link Address: Link address from 0 - FD in hexadecimal numbers (serial only). For dynamic link of
remote copy connections, enter destination port address on the ESCD. For static connections,
enter 0.
• Option button: Opens the RCU Option pane.