HP StorageWorks Continuous Access XP user guide for the XP10000/XP12000 (December 2005)

60 Continuous Access XP for the XP10000/XP12000
default setting is 70 seconds. The value of the Path Blockade SIM Watch cannot be smaller than the
value of the Path Blockade Watch.
Figure 31 System Option pane
Changing subsystem settings
1. In the Continuous Access XP main pane, click Other Operation. The Other Operation pane displays the
Tree.
2. Click a subsystem from the Tree. The Preset List displays subsystem settings.
3. Right-click the list, and select System Option. Current settings appear.
4. Select Set to close the System Option panel. Changes appear in the Preset List.
5. Verify the changes in the Preset List.
6. To change settings, right-click the Preset List, select Modify, make the changes, and close the panel. The
Preset List displays updated information.
7. To omit settings, right-click the Preset List, and select Delete. Changes are cancelled.
8. To cancel changes, right-click the Preset List, and select Delete All.
9. To display error codes, right-click the Preset List, and select Error Detail. Error codes appear on the right
of the Preset List.
10.To apply settings, select Apply (lower right of Continuous Access XP panel). To cancel the operation
and return the list to its original display, select Cancel.
Performing Continuous Access XP configuration operations
Continuous Access XP configuration operations include MCU operations, RCU operations, Continuous
Access XP Asynchronous control operations, and discontinuing Continuous Access XP operations. The
Continuous Access XP main pane (Figure 20 on page 46) provides access to the following Continuous
Access XP configuration operations:
• ”MCU operations” on page 61 configure the MCUs for Continuous Access XP operations
•”Configuring MCU ports” on page 61
• ”RCU operations” on page 61 configure RCUs for Continuous Access XP operations
•”Viewing RCU Status (RCU Status)” on page 62
•”Registering RCUs (Add RCU)” on page 64
•”Modifying RCU options (Change RCU Option)” on page 69
•”Adding and deleting logical paths for RCUs (Add Path/Delete Path)” on page 72
•”Adding and deleting SSIDs for RCUs (Add SSID/Delete SSID)” on page 73
•”Deleting RCUs (Delete RCU)” on page 70
• ”Continuous Access XP Asynchronous operations” on page 75 configure Continuous Access XP
Asynchronous groups and options
•”Modifying parameters and deleting settings” on page 75
•”Adding consistency groups (Add CT Group)” on page 77
•”Modifying consistency group options (CT Group Option)” on page 78
•”Viewing consistency group status (CT Group Status)” on page 76