HP StorageWorks Continuous Access XP Journal user guide (T1778-96001, June 2006)

Continuous Access XP Journal user guide 151
5. If no error occurs in step 4, wait until suspension finishes. After suspension finishes, check whether
there is a secondary data volume (which was originally a primary data volume) whose pair status is
other than PSUS. If such a pair exists, remove the error cause and go back to step 1 after resuming
your business task at the secondary site.
6. If there is no secondary data volume (which was originally a primary data volume) whose pair status
is other than PSUS, data in primary data volumes is the same as data in secondary data volumes, and
the secondary data volume (which was originally primary data volume) is usable. Resume applications
at the primary site.
7. Execute the pairresync -swaps command (pairresync is the RAID Manager XP command for
resynchronizing pair and -swaps is a swap option). This reverses primary and secondary data
volumes to resynchronize pairs.
CAUTION: When executing the pairresync -swaps command, use the -d option to specify a
data volume. However, if the restore journal group where the data volume belongs is in Active,
Halting, or Stopping status, the pairresync -swaps command is rejected. For more information
about journal group status, see ”Displaying detailed information about journal groups” on
page 103.
For more information about using RAID Manager XP, see the HP StorageWorks RAID Manager XP user
guide.
For more information about status of data volumes, see ”Continuous Access XP Journal data volume pair
status” on page 31.