HP StorageWorks Continuous Access XP Journal user guide (December 2005)

76 Continuous Access XP Journal
Continuous Access XP Journal has already been started
1. Select the DKC Operation tab. The DKC Operation pane appears.
NOTE: DKC is an acronym for disk controller, which controls an entire disk array. Continuous Access XP
Journal panes use the word DKC to indicate a disk array.
DKC Operation pane components
Figure 37 DKC Operation pane, DKC option
The DKC Operation pane displays the following:
• Switch Display: Changes information in the DKC Operation pane.
• DKC: Displays information about remote disk arrays and logical paths.
• Port: Displays information about ports on the local disk array.
• Tree: Lists one of the following:
• Remote disk arrays (see ”Displaying information about remote disk arrays” on page 77)
• Channel adapters on the local disk array and port attributes (see ”Displaying information about
logical paths” on page 77)
• List: Displays one of the following:
• Detailed information about remote disk arrays (see ”Displaying information about remote disk
arrays” on page 77)
• Detailed information about logical paths (see ”Displaying information about logical paths” on
page 77)
• Detailed information about ports on the local disk array (see ”Displaying information about ports on
local disk arrays” on page 78)
• Preset: Displays changes made in the pane. When you change settings in the pane, the changes
are displayed in the Preset list before the changes are applied to the disk arrays. If you are sure that
information in the Preset is correct, click Apply to apply the settings you made.
• Operation: Displays the operation in progress in the DKC Operation pane.
• Apply: Applies settings in the Preset box to the disk arrays.
• Cancel: Cancels settings displayed in the Preset box.