HP Hitachi Universal Replicator for Mainframe User Guide (T5278-96044, November 2011)

The table below shows the parameters and detailed information for the settings for AddPair tag.
Table 44 AddPair Tag Parameters and Settings
Range/Character numbersDescription settingParameterColumn
00 to 01LDKC number of the primary data volumeLDKCA
00 to FECU number of the primary data volumeCUB
00 to FFLDEV number of the primary data volumeLDEVC
00 to 01LDKC number of the secondary data volumeLDKC(S)D
00 to FECU number of the secondary data volumeCU(S)E
00 to FFLDEV number of the secondary data volumeLDEV(S)F
00 to 03Mirror IDMirrorIDG
00 to FFID number of the master journal groupM-JNLH
00 to FFID number of the remote journal groupR-JNLI
00000 to 99999Serial number of the secondary storage systemDKCSNJ
4 to 7Controller ID of the secondary storage systemControllerIDK
00Path group IDPathGroupL
N/ACopyModeM
• Entire: Initial copy operation will be executed.
• None: Initial copy operation will not be executed.
• Delta: Without executing the initial copy operation,
a pair for delta resync operation will be created.
1 to 256
1
Priority of the operationPriorityN
N/AErrorLevelO
• Group: When a failure occurs, all the pairs in the
same mirror will be split.
• Volume: When a failure occurs, only the specified
pair will be split.
N/ACFWP
• Only_P-VOL: Cache-fast-write data will not be copied
to the secondary data volume.
• Copy_to_S-VOL: Cache-fast-write data will be copied
to the secondary data volume.
1
When creating a pair, a smaller priority number indicates a higher priority. When creating many pairs at a time,
specifying the Priority parameter may not be enough to manage the priority of pair creation. To be assured of establishing
priority for specified pairs, HP recommends separate spreadsheets for high-priority pairs and other pairs.
NOTE: It is possible to create a Universal Replicator for Mainframe pair for delta resync operation
using a spreadsheet, but Business Continuity Manager is still required to use the delta resync
function. Therefore, it is easier to only use Business Continuity Manager to create pairs for delta
resync operations.
After pairs are created, information about those pairs can be retrieved using the Pair tag. This pair
information will be useful for future operations.
Here is an example:
1. Use the AddPair tag to create Universal Replicator for Mainframe pairs.
2. Retrieve the pair information of the Universal Replicator for Mainframe pairs by using the Pair
tag. The pair information is formatted as follows:
Output example
#!Version 05_02_01, CLI_RemoteCopyJournalMG, Get,;
[Pair]
Creating Pairs (AddPair Tag) 209