XP10000 Disk Arrays and SVS 200 (T1778-96007, October 2007)

• No.: displays serial numbers used for rows in the list

• Path Status: indicates status of a logical path (For details, see Table 27 on page 121)

• Port: indicates a port on the local storage system

• Pair-Port: indicates a port on the remote storage system.

• S/N: indicates the serial number and LDKC number of the remote storage system.

• Controller ID: displays the controller ID (model name that indicates the model) of the remote

storage system.

• Path Gr. ID: indicates a path group ID.

• M-R Path: indicates the type of channel interface between the local and the remote storage

systems. This column displays ﬁbre.

• Minimum Paths: Indicates the minimum possible number of paths between the local and the

remote storage systems.

• RIO MIH Time: indicates the RIO MIH timer value, which is the wait time until data transfer from

the local storage system to the remote storage system is complete.

• DKC Registered: Indicates the date and time when the local and the remote storage systems are

associated to each other.

• Last Updated: indicates the date and time when the last operation on a logical path to the

remote storage system was performed.

• Refresh the DKC Operation tab after this panel is closed: If you select this check box, information

in the DKC Operation window will be refreshed after you close the DKC Status window.

• Refresh: refreshes the information in the DKC Status window.

• Close: closesthe DKCStatuswindow.

12 0

Conﬁguring Disk Storage Systems and Logical Paths