Hitachi TrueCopy (TM) for Mainframe User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array (T5211-96014, May 2011)

Figure 64 Result Statement Format
Table 84 Reserved Result Variables
DescriptionTypeVariable
Stores the execution results of a macro.
0 = normal end. Other values depend
on the macro.
Numeric_Result
Stores the execution results of a
Message (internal) macro.
1 = OK, 6 = Yes, 7 = No.
Numeric_MsgResult
Stores the number of devices found by
SelectHrcDevice macro.
0 = no devices found.
Numeric_SelectResult
Reserved Status Variables
When a GetHrcStatus command is issued, the Remote Web Console computer obtains the status
of the specified TrueCopy for Mainframe pair(s) from the XP disk array. The results of this query
are displayed in the reserved status variables. “Reserved Status Variables” (page 244) lists and
describes the valid reserved status variables.
Table 85 Reserved Status Variables
DescriptionTypeVariable
Stores the copy type: “RDC” = remote
copy mode ; “RMC' = migration mode;
“---” = other than the above modes.
String_HrcStatus _CopyType
Stores the device attribute: “M-Vol” =
M-VOL “R-Vol” = R-VOL “---” = other
than the above modes.
String_HrcStatus _DeviceAttr
Stores the M-VOL device number.Numeric_HrcStatus _DeviceM
Stores the R-VOL device number.Numeric_HrcStatus _DeviceR
Stores the serial number of the controller
for the remote pairs.
String_HrcStatus _Sn
Stores the storage subsystem ID (SSID)
of the controller for the remote pairs.
Numeric_HrcStatus _Ssid
Stores the pair status: “Simplex” =
simplex; “Duplex” = duplex; “Pending”
= initial copy in progress;
“Suspended0” = copy abort in initial
copy; “Suspended1” = copy abort other
than initial copy; “Suspending” =
TrueCopy for Mainframe Asynchronous
suspend in progress; “Deleting” =
TrueCopy for Mainframe Asynchronous
delete in progress; “Undefined” =
undefined.
String_HrcStatus _PairStatus
244 TrueCopy for Mainframe Scripting