Hitachi TrueCopy (TM) for Mainframe User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array (T5211-96014, May 2011)

specified. The maximum number of devices is 1,024. To search for more than 1,024 devices,
repeat this command for several times.
When you write device list, you can omit LDKC# if the LDKC# is 0. For example, you can
write 0x0102 when LDKC# is 0, CU# is 1, and vol# is 2.
• Serial number list (string): RCU serial number. Default = not specific.
• SSID number list (numeric): RCU SSID. Default = not specific.
• Fence level list (string): “N” or “Never” = never; “S” or “Status” = status; “D” or “Data” =
data. Default = not specific.
• Sync level list (string): “S0” or “Synchronous0” = sync, “S2” or “Synchronous2” = async.
Default = not specific.
• Pair status list (string): “Simplex”, “Pending”, “Duplex”, “Suspended0” (suspended during
initial copy), “Suspended1” (suspended after initial copy), “Suspended” (all suspend types),
“Suspending”, “Deleting”, “Undefined”. Default = not specific.
• Device attribute list (string): “M” or “M-Vol”, “R” or “R-Vol”. Default = not specific.
• Error level list (string): “G” or “Group”; “V” or “Volume”. Default = not specific.
• CT group list (numeric): consistency group number (0x00 - 0x7F). Default = not specific.
• SEQCHK flag list (string): “Yes” = SEQCHK on; “No” = SEQCHK off. Default = not specific.
“SelectHrcDevice Command” (page 239) provides an example of the SelectHrcDevice command
to find the pairs with the parameters listed in “Select Device Parameters” (page 238).
Table 78 Select Device Parameters
ValueParameter
_ilDevAOutput list
_ilDevBDevice list
_slWorkARCU serial number
_ilWorkARCU SSID
NFence level
S0, S0, S0Copy mode
Suspended0Pair status
MDevice attribute
238 TrueCopy for Mainframe Scripting