Hitachi TrueCopy for z/OS (T1711-96009, June 2006)

TrueCopy for z/OS user guide 169
• If mode 484 is ON, the status of path as using the fibre channel interface will be displayed. If mode
484 is OFF, ESCON will be indicated for the path status.
• If the former type subsystem or the subsystem of TagmaStore USP microcode version 50-05-XX-XX or
earlier is connected, mode 484 must be OFF.
Output Example: CQUERY
CGROUP (FREEZE/RUN) Support
The TC390 feature supports the CGROUP (FREEZE/RUN) TSO command for PPRC, which is also used in
IBM’s Geographically Dispersed Parallel Sysplex (GDPS) environment. The CGROUP TSO command is
used to control I/O operations for TC390 Synchronous pairs on a specific MCU-RCU pair. The CGROUP
command is supported for the XP1024/XP128/XP12000/XP10000 (and other XP disk arrays)
functioning as TC390 MCUs. The XP disk arrays provides all required host reporting for CGROUP
operations (for example, IEA494I with extended long busy (ELB) state), which is a key component of GDPS
operations. For disaster recovery implementations, you must use the XP1024/XP128/XP12000/XP10000
at both sites because the RCUs will become MCUs in the event of a disaster.
************** PPRC REMOTE COPY CQUERY - VOLUME *********************
* (PRIMARY) (SECONDARY) *
* SSID CCA LSS SSID CCA LSS *
*DEVICE LEVEL STATE PATH STATUS SERIAL# SERIAL# *
*------ --------- ---------- ----------- --------- --------- *
* 2A10 PRIMARY.. PENDING... ACTIVE.. 4300 10 00 4300 11 00 *
* CRIT(NO)....... CGRPLB(NO). 00A7FS0V0000 000000099999 *
* PATHS SAID DEST STATUS: DESCRIPTION *
* ----- --------- ------ ------------------- *
* 1 aabb ccdd 01 PATH ESTABLISHED... *
* ---- ---- 00 NO PATH............ *
* ---- ---- 00 NO PATH............ *
* ---- ---- 00 NO PATH............ *
* IF STATE = PENDING/SUSPEND: TRACKS OUT OF SYNC = 47277 *
* TRACKS ON VOLUME = 50085 *
* PERCENT OF COPY COMPLETE = 6% *
* SUBSYSTEM WWNN LIC LEVEL *
* ----------- ---------------- ----------- *
* PRIMARY.... 0000000000000000 3.8.05.0000 *
*********************************************************************
Table 45 CQUERY output for serial and Fibre Channel
LINK
Parameter
Serial (ESCON) Interface Fibre Channel Interface
Mode 484 OFF
Fibre Channel Interface
Mode 484 ON
aa FREEZE option
0x00:keep the status
0x01:Enabled
0x02:Disabled
Bit 0-3: RCU controller ID
x2-xF: Number stands for RCU
controller ID.
Bit 4-7: FREEZE option
x0:keep the status
x1:Enabled
x2:Disabled
SAID of MCU
(x'00' and the port number)
bb MCU port number (0x00-0x1f) MCU port number (0x00-0xff)
cc Link Adr (0x00-0xff) RCU port number (0x00-0xff) SAID of RCU
(x'00' and the port number)
dd CU number (0x00-0x1f) CU number (0x00-0xff)