Hitachi ShadowImage for z/OS user guide (HIT9503-96009, January 2008)

Table 23
Parameter
Restriction
Error Report
PRIMARY
Siz does not use
the PRIMARY
parameter with
in the SUSPEND
command.
MSGREQ
This parameter cannot be used for
ICKDSF when the volume specified
as the S-VOL or T-VOL is used for
TCz.
When the volume specified as
the S-VOL is used for TCz, check
the pair status by executing the
QUERY command to the T-VOL.
Ifyouspecifythevolumewhichis
sharedwithTCzandURzM-VOL
(P-VOL) as Siz S-VOL, and if the
pair status of the TCz pair is
Duplex, the job of the ESTPAIR
command will end normally before
the copying processing of the
Siz pair completes even when
YES is specified for the MSGREQ
parameter.
When the volume specified as
the T-VOL is used for TCz, check
the pair status by executing the
QUERY command to the S-VOL.
QUIESCE
This parameter cannot be used
when the disk controller emulation
t ype i s 2105 o r 2107. To use t hi s
parameter, set the disk controller
emulation type to 3990.
In case of TSO, Siz ignores this
parameter.
In case of ICKDSF, the job ends
abnormally (CC=12).
ONLINESEC
Onli
ne check is not available
when
you perform backward
res
ynchronization by the ICKDSF
com
mand. If you specify NO for
thi
s parameter, or if you do not
sp
ecify the parameter, an error
oc
curs whether the volume is
on
line or offline.
Al
though no error occurs when
you specify YES for this parameter,
note that the copying operation
i
sperformedwithoutanyonline
check.
In case of ICKDSF, the job ends
abnormally (CC=12).
Set Path
Siz does not use the Set Path
parameter.
Hitachi ShadowImage for z/OS user guide
105