Hitachi ShadowImage for z/OS user guide (HIT9503-96009, January 2008)

Command
Parameter
Value
Description
QUERY
DDNAME,SYSNAME,or
UNITADDRESS
DDNAME = dname =
JCL statement identifying
the volume.
SYSNAME = sysxxx =
SYSNAME in the ASSGN
system control statement.
UNITADDRESS = ccuu =
device number.
You should specify only
one parameter of the
three parameters. The
italic part on the left
meansthatitisthe
arbitrary name. For
example, dname means
the arbitrary unique name
of the JCL statement which
identifies the volume.
PATHS
Not applicable.
Siz does not
use this
parameter
.Sizignoresit.
PPRC Restrictions
Table Table 22 on page 104 and describes the restrictions for using PPRC commands with Siz volumes.
Table 22 Restrictions for PPRC Commands
Command
Restriction
Error Report
ESTPAIR Command
SUSPEND Command
Do not issue ESTPAIR or SUSPEND
command to a PENDING device.
PPRC PENDING STATUS CC = 12
RECOVER Command
Recovery commands are not valid,
because Siz pairs are constructed
within the same storage system
NOTE:
If a reco
very command is used
by mistake, the result is the same
as a delete pair command,
except w
hen VOLID is specified.
PPRC PENDING STATUS CC = 8
Table 23 on page 105 lists and describes the restrictions for using parameters of PPRC commands
with Siz
volumes.
104
Using PPRC Commands for Hitachi ShadowImage for z/OS