Hitachi ShadowImage for z/OS user guide (HIT9503-96004, June 2006)

134 ShadowImage for the XP1024/XP128/XP12000/XP10000
Figure 88 Example of FCWITHDR Command Description (for Case 7)
Since no relationship is withdrawn by performing the abovementioned command, there will be no change
in the number of relationships after using the command.
Note that even if you do not issue this command, the write operation to volumes may be resumed
automatically if the state-change-pending delay time elapses. For information about the
state-change-pending delay time, see ”The Detail Window” on page 47.
CAUTION: When the relationships are withdrawn by the FCWITHDR command executed with DDSW
parameter set to NO or without setting the DDSW parameter, the data integrity of the T-VOL cannot be
guaranteed.
CAUTION: If you use the FCWITHDR command only one time when deleting numerous relationships, a
timeout might occur with the host. Use the FCWITHDR command more than one time when deleting
numerous relationships. Also, after you execute the FCWITHDR command one time, wait for a while before
executing the FCWITHDR command again. For example, if you execute the FCWITHDR command one
time when deleting 700 relationships, wait for approximately 5 seconds before executing the command a
second time.
Displaying Information on FlashCopy Mirror Version 2 Pairs: FCQUERY
The FCQUERY command can be used to display information including the attributes set to the devices
specified by DEVN, and the number of FlashCopy Mirror Version 2 relationships established with the
specified devices.
The figure below shows an example of the FCQUERY command. This example requests the information on
the device numbered 4202 to be displayed.
Figure 89 Example of FCQUERY Command Description
The figure below shows the information displayed as a result of executing the command described above.
Definition of each displayed information is explained in Table 60.
Figure 90 Example of FCQUERY Command Execution Result
FCWITHDR DEVN(X'4202') ACTION(THAW)
FCQUERY DVEN(X'4202')
ANTF0090IF CQUERY Formatted
DEVN SSID LSS CCA CU SERIAL ACT MAX XC PC CC RV SEQNUM
4202 0102 02 02 2105 000000045029 1 1000 N N N N 00000000
Table 60 Information Displayed by FCQUERY Command
Displayed
item
Displayed
content
Definition
DEVN Device number recognized by the host
SSID Subsystem number
LSS CU number