Hitachi ShadowImage for z/OS user guide (December 2005)

114 ShadowImage for the XP128/XP1024/XP10000/XP12000
6. If the T-VOL is set to offline in step 4, set this volume back to online. This step is not necessary if the
ONLINTGT parameter of the FCESTABL command is set to YES.
NOTE: FCESTABL command can only be executed once per FlashCopy Mirror Version 2 pair. In
other words, you cannot execute this command repeatedly for the same FlashCopy Mirror Version 2
pair.
Figure 59 shows an example of how FCESTABL command is used. In this example, the FCESTABL
command specifies that the data on the extent starting from CCHH '01000004' and ending at CCHH
'0357000A' in the source device numbered 4202 is to be copied to the extent starting from CCHH
'13000001' and ending at CCHH '15570007' in the target device numbered 4203, and the operation
mode for copying to the extent starting from CCHH '18A00000' and ending at CCHH '18F30006' is to
be set to NOCOPY mode.
Figure 59 Example of FCESTABL Command (NOCOPY)
Figure 60 shows another example of how FCESTABL command is used. In this example, the FCESTABL
command specifies that the data in the source device numbered 4202 is to be copied to target device
numbered 4203 by COPY mode while 4202 is online.
Figure 60 Example of FCESTABL Command (COPY)
Withdrawing FlashCopy Mirror Version 2 Pairs: FCWITHDR
FCWITHDR command can be executed to FlashCopy Mirror Version 2 pairs that are already created.
Table 57 describes the parameters of FCWITHDR command and the applicable combinations.
FCESTABL SDEVN(X'4202') TDEVN(X'4203') MODE(NOCOPY)
XTNTLST(X'01000004' X'0357000A' X'13000001' X'15570007',
X'02AC0006' X'02FF000C' X'18A00000' X'18F30006')
FCESTABL SDEVN(X'4202') TDEVN(X'4203') MODE(COPY) ONLINTGT (YES)
Table 57 Parameters of FCWITHDR Command and Applicable Combinations
Case No. SDEVN TDEVN DDSW XTNTLST Process
Source Target
1Not
specified
Specified NO Not
specified
Not
specified
All the relationships established with the
copy target extents existing in the device
specified by TDEVN are withdrawn. The
relationships established with the copy
source extents existing in the specified
volume are not withdrawn. See
Figure 61.
2Not
specified
Specified NO Specified Specified The relationships included in the extents
specified by the XTNTLST parameter are
withdrawn. The relationships that are
only partly included in the specified
extents are not withdrawn. See Figure 63
and Figure 65
3SpecifiedSpecifiedNONot
specified
Not
specified
All the relationships established between
the source device specified by SDEVN
and the target device specified by
TDEVN are withdrawn. See Figure 67.