Hitachi ShadowImage for Mainframe User Guide: HP XP24000 Disk Array, HP XP20000 Disk Array (T5213-96032, May 2011)

Table 35 PSF Command Operability for ShadowImage for Mainframe Volumes (continued)
Operability for ShadowImage for MainframeItem
Active.Path status.
If the volume does not also belong to a TCz pair, 1 is
displayed with TCz info.
Path number.
Table 36 (page 95) describes the PSF Read Subsystem Data and DEVSERV Sense Subsystem Status
results for SIz volumes.
Table 36 PSF and DEVSERV Results for ShadowImage for Mainframe Volumes
DEVSERV Sense Subsystem StatusPSF Read Subsystem DataPair Status
T-VOLS-VOLT-VOLS-VOL
PSEC-PNDGPPRI-PNDGPSEC-PNDGPPRI-PNDGPending
PSECONDRYPPRIMARYPSECONDRYPPRIMARYDuplex
PSEC-PNDGPPRI-PNDGPSEC-PNDGPPRI-PNDGSP-Pend
SIMPLEXPPRI-SUSPPSEC-SUSPPPRI-SUSPV-Split
SIMPLEXPPRI-SUSPPSEC-SUSPPPRI-SUSPSplit
PSEC-SUSPPPRI-SUSPPSEC-SUSPPPRI-SUSPSuspend
PSEC-PNDGPPRI-PNDGPSEC-PNDGPPRI-PNDGResync
NOTE: PPRIMARY and PSECONDRY indicate that the volume is in the duplex state.
Figure 39 (page 95) shows an example of the DEVSERV command.
Figure 39 DEVSERV Command
97244 13:04:37.39 DS P,DE80,1
97244 13:04:38.57 IEE459I 13.04.37 DEVSERV PATHS 692
692 UNIT DTYPE M CNT VOLSER CHPID=PATH STATUS
692 RTYPE SSID CFW TC DFW PIN DC-STATE CCA DCA
692 DE80,33903 ,0,000,DKDE80,54=+ 1C=+ D4=+ 9C=+
692 0080 Y YY. YY. N PPRIMARY 00 00
Adding Pairs Using PPRC Commands
The CESTPAIR and PPRCOPY ESTPAIR commands are equivalent to the SIz add pair operation.
The CESTPAIR and PPRCOPY ESTPAIR commands must be issued to the S-VOL of the pair being
created, and the T-VOL must be offline to the host before these commands are issued.
This section describes the parameters and examples of the CESTPAIR and the PPRCOPY ESTPAIR
command.
CESTPAIR (Adding Pairs)
Table 37 (page 96) lists and describes the CESTPAIR command parameters that can be used when
you create SIz pairs.
Adding Pairs Using PPRC Commands 95