Hitachi ShadowImage for IBM z/OS User"s Guide (T5213-96002, June 2007)

5-10 Performing ShadowImage for z/OS Operations Using Storage Navigator
Hitachi ShadowImage™ for IBM
®
z/OS
®
User’s Guide
Configuring Consistency Groups
This section describes the instructions on setting or resetting the reserve
attribute to a consistency group. If you want to check the information of the
pairs in the consistency group before set the reserve attribute to the group, do
the following procedure:
1. Display the CTG window (see Figure 4-6).
Note: If you are already displaying the other window shown by a tab, click
the CTG tab. For information about how to display the CTG window directly
by starting up Storage Navigator, see section Starting ShadowImage for
z/OS.
2. Select and right-click the consistency group in the CTG List in the window.
The pop-up menu is displayed.
3. Select the CT Group Status command in the pop-up menu.
The CT Group Status dialog box is displayed.
Note: The information of the registered pairs displayed in the CT Group Status
dialog box is only for display and cannot be edited to perform any pair
operation.
Figure 5-4 The CT Group Status Dialog Box
The items displayed in the CT Group Status dialog box are as follows:
• CTG drop-down list allows you to select the consistency group that you
want to display in the Pair Information List.
• Pair Information List, located below the CTG drop-down list, displays the
following information pertaining to the pair or pairs registered in the
selected consistency group.