Hitachi ShadowImage for IBM z/OS User"s Guide (T5213-96002, June 2007)

Performing ShadowImage for z/OS Pair Operations Using PPRC 7-21
Hitachi ShadowImage™ for IBM
®
z/OS
®
User’s Guide
When a command is issued to the target volume (T-VOL) in a consistency
group, the field for displaying the serial number of SECONDARY will be
outputted in the format shown below.
00S@00030158
Indicates the serial number of SECONDARY.
Indicates that the current status is either in the
process or completion of the split operation
executed by the ATSPLIT command.
Indicates that the pair belongs to a consistency
group.
QUERY
Table 7-16 lists and describes the QUERY command parameters that can be
used when you refer to the status of SIz pairs.
Table 7-16 QUERY Command Parameters
Parameter Value Description
DDNAME,
SYSNAME, or
UNITADDRESS
DDNAME = dname = JCL
statement identifying the volume.
SYSNAME = sysxxx = SYSNAME
in the ASSGN system control
statement.
UNITADDRESS = ccuu = device
number.
You should specify only one parameter of
the three parameters. The italic part on the
left means that it is the arbitrary name. For
example, dname means the arbitrary
unique name of the JCL statement which
identifies the volume.
Figure 7-11 shows an example of the QUERY command.
0
0 PPRCOPY QUERY UNIT(6400)
-ICK00700I DEVICE INFORMATION FOR 6400 IS CURRENTLY AS FOLLOWS:
- PHYSICAL DEVICE = 3390
- STORAGE CONTROLLER = 2105
- STORAGE CONTROL DESCRIPTOR = E8
- DEVICE DESCRIPTOR = 0A
- ADDITIONAL DEVICE INFORMATION = 4A000035
- TRKS/CYL = 15, # PRIMARY CYLS = 3339
0ICK04030I DEVICE IS A PEER TO PEER REMOTE COPY VOLUME
0
0 QUERY REMOTE COPY - VOLUME
0
(PRIMARY) (SECONDARY)
SSID CCA SSID CCA
DEVICE LEVEL STATE PATH STATUS SER # LSS SER # LSS
0------ --------- -------------- ----------- ----------- -----------
6400 PRIMARY DUPLEX ACTIVE 2700 00 2700 01
63515 00 63515 00
0
PATHS SAID/DEST STATUS DESCRIPTION
----- --------- ------ ----------------
1 FFFF FFFF 01 PATH ESTABLISHED
0
0