Hitachi ShadowImage for IBM z/OS User"s Guide (T5213-96002, June 2007)

7-2 Performing ShadowImage for z/OS Pair Operations Using PPRC
Hitachi ShadowImage™ for IBM
®
z/OS
®
User’s Guide
PPRC Command Support
Table 7-1 lists and describes the PPRC commands supported by ShadowImage
for z/OS.
Table 7-1 PPRC Commands Available for SIz
TSO Command ICKDSF Command Function Specified Volume
CESTPAIR PPRCOPY ESTPAIR Adds a pair, starts initial copy operation,
and changes status to duplex.
Simplex volume that to be
the S-VOL.
CESTPAIR PPRCOPY ESTPAIR Adds and simultaneously splits a pair. Simplex volume that to be
the S-VOL.
CSUSPEND PPRCOPY SUSPEND Splits a pair, starts quick split operation. Duplex or pending S-VOL.
CSUSPEND PPRCOPY SUSPEND Splits a pair, starts steady split operation. Duplex or pending S-VOL.
CESTPAIR PPRCOPY ESTPAIR Resynchronizes a pair, starts normal
resync.
Split, V-split or suspended
S-VOL.
CESTPAIR PPRCOPY ESTPAIR Resynchronizes a pair, starts quick resync. Split, V-split or suspended
S-VOL.
CESTPAIR PPRCOPY ESTPAIR Resynchronizes a pair, starts reverse copy. Split S-VOL.
CESTPAIR PPRCOPY ESTPAIR Resynchronizes a pair, starts quick restore. Split S-VOL.
CDELPAIR PPRCOPY DELPAIR Deletes a pair, changes status to simplex. Other than simplex S-VOL.
CQUERY PPRCOPY QUERY Displays detailed pair status information. Any volume status is OK.
Notes:
– You cannot set or reset the reserve attribute by using the PPRC
commands. To set or reset the reserve attribute, use the Storage
Navigator computer.
– The ShadowImage for z/OS suspend operations cannot be requested
using PPRC commands. The CSUSPEND/PPRCOPY SUSPEND commands
execute split operations on ShadowImage for z/OS pairs. Use the
Storage Navigator computer to suspend SIz pairs.
– If you issue the ESTPAIR or the SUSPEND command to a Pending
volume, the command will abnormally end by reporting CC = 12.
– CRECOVER command is not supported by ShadowImage for z/OS. When
you try to execute the CRECOVER command on the SIz S-VOL, the
command ends normally and the SIz pair will be deleted. If you execute
the command on the SIz T-VOL, the command will be rejected and end
abnormally by reporting CC = 8.
– CGROUP command is not used for ShadowImage for z/OS. For
information on the CGROUP command, see the TrueCopy for IBM z/OS
User’s Guide.