HP Remote Graphics Software 5.4.8 User Guide

Remote audio on Linux
RGS on Linux also supports remote audio, allowing audio generated by the application on the Remote
Computer to be captured and transmitted to the Local Computer for playback.
Figure 2-24 RGS audio
subsystem on Linux on page 41 shows the RGS audio subsystem (green boxes), and the audio data
paths for Linux—these data paths are described in
Table 2-7 Linux RGS audio data paths
on page 42. To simplify comparison with Windows, all audio components shown on the Windows
diagram in
Figure 2-23 RGS audio subsystem on Windows on page 38 are retained below, but
partially obscured if not supported on Linux.
Figure 2-24 RGS audio subsystem on Linux
Table 2-7 Linux RGS audio data paths on page 42 describes each of the audio data paths. The
numbering and lettering in the table correspond to the numbering and lettering in
Figure 2-23 RGS
audio subsystem on Windows on page 38. For a list of audio devices supported on Linux Remote
Computers, see
Linux remote audio device support on page 235 .
Remote audio
41