HP Remote Graphics Software 5.4.8 User Guide

Remote audio
This section describes RGS support of remote audio on Windows and Linux. Rather than describe all
four combinations of Remote and Local Computers running Windows and Linux, the following sections
describe remote audio when both computers are running Windows, followed by a remote audio
description when both computers are running Linux.
Remote audio on Windows
RGS on Windows supports remote audio, allowing audio generated by the application on the Remote
Computer to be captured and transmitted to the Local Computer for playback. In addition, microphone
input on the Local Computer running Windows XP can be sent to the application running on the Remote
Computer also using Windows XP. Remote microphone is not supported on Windows 7.
Figure 2-23
RGS audio subsystem on Windows on page 38 shows the RGS audio subsystem (green boxes) for
Windows, and the audio data paths—these data paths are described in
Table 2-6 Windows RGS
audio data paths on page 39.
Figure 2-23 RGS audio subsystem on Windows
Table 2-6 Windows RGS audio data paths on page 39 describes each of the audio data paths. The
numbering and lettering in the table correspond to the numbering and lettering in
Figure 2-23 RGS
audio subsystem on Windows on page 38.
38 Chapter 2 RGS overview