HP Remote Graphics Software 5.4.8 User Guide

If Rgsender.Network.IsListenOnAllInterfacesEnabled=0, the Sender will listen on any network interface
“n” where Rgsender.Network.Interface.n.IsEnabled=1, and the Receiver IP address is in the range
specified by this property.
Rgsender.Network.Port=int (42966)
This property controls the port used for communications with the RGS Sender. If this property is not
specified, the Sender will listen on port 42966, which is the default port used by the Receiver in
establishing a connection to the Sender. If this property is used to modify the Sender port number, the
user will need to specify the same port number on the Receiver to establish a connection with the
Sender, as described in
Using RGS in Normal Mode on page 101.
Sender clipboard property
Rgsender.Clipboard.IsEnabled=bool （1）
If set to 1, Remote Clipboard is enabled—specifically, the copy and cut functionality in the Remote
Display Window is enabled. If set to 0, the copy and cut functionality is disabled. The default value is 1
—Remote Clipboard is enabled.
Rgsender.Clipboard.IsAlwaysAuthorized=bool （1）
If set to 1, Remote Clipboard works on a limited permissions receiver window for collaboration mode.
RGS Sender properties
205